Radio motor R - 10 Nm + Bubendorff remote control

Is the R radio engine centralizable?

The R radio motor cannot be centralized with other shutters if you are replacing a motor in an existing shutter installation that was operating with a carrier current protocol (centralization via the electrical network).
On the other hand, this motor is potentially centralizable using the radio protocol of the motor, this means that the motors of your roller shutters having been replaced by motors of this same type R (radio protocol) can be centralized with one of the following Bubendorff radio remote controls :

• Additional transmitter to control 1 group of up to 20 shutters
• 5-channel remote control to control up to 5 groups of up to 20 shutters
• 4-channel remote controls with clock to control and program up to 4 groups of shutters

If you want the motor to be replaced to be immediately compatible with your current centralization, then take the RG motor.

How to be sure of the motor torque to choose?

R motors are now available in 10 Nm, 25 Nm and 33 Nm torque. If 6 or 10 Nm is marked on your motor, you can be sure that the 10 Nm motor will be suitable. If it is registered 20 or 25 Nm, you can take the 25Nm motor and if it is registered 30 or 33 Nm then orient yourself on the 33 Nm.

It is not advisable to take a torque higher than that which is in place. In fact, as the engine is stopped by force at the level of the high and low stops, you risk breaking the fasteners of the apron (called automatic locks) of the shutter on their axis, or even damaging the blades of the apron.
However, if you want to increase the torque of your motor, remember to add one or two pairs of automatic locks to your order.

If you have any doubts about the engine torque in place, do not hesitate to send us a request with the SN number of the shutter either by chat (bottom right) or via our form.

This engine seems longer than the one I currently have, is it compatible?

Don't worry, this motor model is compatible with your shutter, you will just have to drill the metal shaft further to rivet it, be careful not to drill the motor, the guarantee would be inapplicable.

Is the motor sold with its remote control, will my old control still work?

All Bubendorff radio motors are sold with a transmitter previously paired in the factory with the motor, your old transmitter will not be able to control this new motor under any circumstances, and if you need an additional control, you will have to add a transmitter to your order. additional removable.

Is there a particular commissioning setting on this model?

No, powering up and setting the shutter to the upper and lower stops will allow it to initialize on its own, if you do not want the shutter to stop at the upper stop automatically, it will then be possible to configure it (only the top stop can be configured).
The upper stop adjustment steps are available in the downloadable instructions in the "Attached files" tab.