- Back to top
- Description
- Documentation
- Options details
- Features
- Customer reviews
The most compact high performance dual flow vmc on the market
The best of double flow VMC with a reduced size . Concretely, its depth is 455mm. Compared to the Flair 325, this is 11cm shorter . The width is 60 cm and its height is 65 cm, its weight is 29 kg.
Its reduced dimensions allow it to install this vmc in a reduced technical room. It allows an air flow of 225 m3/h maximum.
Like all double-flow CMVs in the FLAIR range, the FLAIR 225 operates at a constant airflow: Indicate the desired air renewal flow and the CMV will provide it regardless of the network pressure drops or the clogging of the filters (which it will still be necessary to vacuum every 3 months - valid advice whatever the type of double flow vmc).
Its use is recommended from T2 to T5+ (for accommodation up to approximately 120 m2 or 350 m3).
In terms of thermal efficiency , the figures are 92% according to EN 13147-7 and 89% according to Passive House Institute
A double flow vmc with one of the lowest consumption on the market
0.17Wh/m3 according to EN1314-7 and 0.25 Wh/m3 according to PassivHaus Institute measurements
Very low consumption, constant flow fan motors
Efficiency class A+ with 2 sensors coupled to the 2-zone ventilation set.
Easy installation and use
You can place this vmc either on a wall (anti-vibration pads allow you to have a silent installation) or on the ground on a frame.
Commissioning is extremely simple ("Plug and Play"). Note that you are alerted if the filters are clogged. Thus, regular maintenance allows you to extend the life of your plant.
Access to the filters on the front makes it easy to change them, a few seconds are enough.
Some additional info:
- Electric pre-heater as standard
- Bypass 100% as standard
- Motor consumption: 0.17 Wh/m3 according to EN 13147-7 and 0.25 Wh/m3 according to PHI
- Standard control: touch screen with integrated maintenance and commissioning assistant
- 60% IC (G4) / 60% IC (G4) filters as standard
- Numerous regulation possibilities
- Modularity of connections (above / below)
The complete technical sheet is available in the "documentation" section.
Our design office is there to support you. Do not hesitate to tell us about your project.
Options Details
White steel mounting frame for Flair 325 or Flair 400.
To control the VMC from your kitchen (boost kitchen)
The FLAIR "Plus" option comes in the form of a different electronic board. It has the following additional features:
The dry trap supplied with the machine is not sufficient to prevent odours from rising from the drainage system as it is not airtight.
- Certification NF
- Label passive house institute
- A+
- A
- 42.5 dB(A) (PHI certified)
- 2 years - 5 years conditionally
Left version:
- Managing the air flow inside the home is done with the left fittings.
For model 2/2 the left fittings are at the bottom of the VMC.
- The air passage outside the home is managed with the right-hand fittings.
Right version:
- The air passage inside the house is managed with the right-hand fittings.
For model 2/2 the right fittings are at the bottom of the VMC.
- Managing the air flow outside the home is done with the left fittings.
- Less than 250 m3
- Between 250 and 300 m3
- DN 125
No reviews found
You have a question ?